Signamax 10/100 Industrial DIN-rail Mount Power over Ethern Bedienungsanleitung PDF herunterladen (Seite 14)

Hardened PoE Ethernet Switch

Installation

This chapter gives step-by-step instructions about how to

install the switch:

Selecting a Site for the Switch

As with any electric device, you should place the switch

where it will not be subjected to extreme temperatures,

humidity, or electromagnetic interference. Specifically, the

site you select should meet the following requirements:

- The ambient temperature should be between -40 to 75

degrees Celsius.

- The relative humidity should be less than 95 percent,

non-condensing.

- Surrounding electrical devices should not exceed the

electromagnetic field (RFC) standards.

- Make sure that the switch receives adequate ventilation.

Do not block the ventilation holes on each side of the

switch

- The power outlet should be within 1.8 meters of the

switch.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Signamax 10/100 Industrial DIN-rail Mount Power over Ethern Bedienungsanleitung Seite 14