Signamax 10/100BaseT/TX to 100BaseFX Converters w/USB Power Bedienungsanleitung PDF herunterladen (Seite 12)

Signamax

™

10/100TX to 100FX Media Converter

User’s Manual 9

Installation

This chapter gives step-by-step installation instructions for

the Converter.

Selecting a Site for the Equipment

As with any electric device, you should place the equipment

where it will not be subjected to extreme temperatures,

humidity, or electromagnetic interference. Specifically, the

site you select should meet the following requirements:

 The ambient temperature should be between 32 and 104 degrees

Fahrenheit (0 to 40 degrees Celsius).

 The relative humidity should be less than 90 percent, non-condensing.

 Surrounding electrical devices should not exceed the electromagnetic field

(RFC) standards for IEC 801-3, Level 2 (3V/M) field strength.

 Make sure that the equipment receives adequate ventilation. Do not block

the ventilation holes on each side of the equipment.

 The power outlet should be within 1.8 meters of the product.

Connecting to Power

This Converter is a plug-and-play device.

Connect the USB powering cable to the USB bus power connector

on the rear panel of the converter.

<NOTE> Don’t connect two media converters to the USB ports of the PC or

notebook computers through the USB power cables at the same time.

And/ or Connect the supplied AC to DC power adaptor to the

receptacle on the rear panel of the converter, and then attach the

plug into a standard AC outlet with a voltage range from 100 to

240VAC.

1 2 ... 7 8 9 10 11 12 13 14

Keine Kommentare

Signamax 10/100BaseT/TX to 100BaseFX Converters w/USB Power Bedienungsanleitung Seite 12